My S2 tram lines terrible and seems to wonder all over the road, noticed this with the front wheels.. near side top of tyre is well inside the arch, drivers side is flush. Advice what is wrong??
-
-
probably the hub to strut bolts were no tight enough and it has slipped.
If the ball joint had slipped, the bottom of the tyre would have come outwards
Panthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 Avant -
or what error says, or the subframe is into full right position.Audi Quattro WRComment
-
will make the car pull funny and generally feel crap! make sure once they have adjusted the tracking that everything is fully tightened back up to recomended torque settings as stated by error they can slip.Comment
-
In my experiace our cars can go out of alignment very easily if potholes and the like are encountered.
A down side to being fully adjustablesigpic
"For what you spent on that you could have brought a new car"
BUT I DON'T WANT A NEW CAR!
1995 S2 Avant, Volcano Black
1982 VW Golf Mk1, primer yellow, will be finished one day, maybe.
2003 VW T4 long nose X pack, (has become project)Comment
-
I had the same thing, do all measurements from subframe out to end of hubs, body work is not a reliable referance point. Found out one of my wings is nearly 6mm different from the other so makes wheels look well out when infact they are fine
. My car has been repaired in it's history at some point and the wings are out not the wheels
Comment
-
.
And if all else fails, check the ET on the wheels is the same on both sides.Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
Comment