lowering my "s2" limo

[hermanio]

i have an audi 80 competition wich i rebuild to s2 limo. the car has a full rs2 drivetrain. as you can see on the picture the "problem" i have now is that the back of the car sits to high. my question is can i use 80 quattro b4 limo springs on the rs2 struts to lower the car a bit ?

http://cgi.ebay.de/H-R-FEDERN-AUDI-8...ht_2089wt_1139

[A80Avant]

is this how it looks with original RS2 springs and shocks?

[hermanio]

yes

[A80Avant]

if it is that high then with HR springs it should look awesome!

[Skull]

yes the springs will fit perfectly...

[hermanio]

hey skull, what springs are you using on the back ? or are you using coilovers ?

[Skull]

no, i am using KAW audi 80 quattro springs and bilstein B8 rear struts, which have been modified to allow a -2 +4cm regulation.

[hermanio]

do i get any problems using v6 springs ? because of the slightly lower weight of the v6..

[Skull]

higher front...

[hermanio]

but i also want al slightly lower front, not easy to find good springs i think ?

[Rocco]

this car in black its a near brother of mine

do you have it tuned??

[hermanio]

only chipped, i think it would look so much better if the car would sit a little lower

[Skull]

do it like me, bilsteins all around, and kaw 60/40 springs. on the front it will be just right with a little heavier engine,on the rear it is cool as with the mod you can set the height to match the front...

[hermanio]

are you using these ?

http://cgi.ebay.de/KAW-FEDERN-Audi-8...#ht_2753wt_905

[Skull]

yes those should be them, i dont remember if they were "s2" units or not, but all the rest is right.

they are not as hard as eibach springs