RS6 replicas - bolt length

[nickhey]

Just bought a nice set of RS6 replicas from Imster ( cheers ).

Only one slight snag, the OE wheel bolts do not appear to be long enough. I'm only getting about 4 complete turns before they start to bite, as opposed to 8 or 9 on the original Avus wheels.

I checked with Audi the size of the OE bolts for both S2, RS2 and RS6 and they are all the same - M14 x 1 thread, 27mm long.

Any ideas where I can get hold of some longer bolts of the correct material / tensile strength etc? ( obviously I'm not interested in using any old bolts )

Aas above size, around 30 - 35mm would do the trick.
Cheers,

Nick

[SteveH]

Would also be worth checking if these alloys use a taper bolt or radius type like Audi use. Both of my aftermarket sets of alloys have the taper style bolt - Oz & Milli

[Crawford_S2]

Also make sure you dont end up with bolts too long, you can screw up the ABS sensors if they are!

[Fat Audi 80]

I would take some proffessional advice on that one!

[nickhey]

Thanks for the feedback.
I'll try to check with the supplier what they recommend ( once I know who that is ).
Cheers,
Nick