Early 3B rear bolts (M12)- NLA?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • sidrick
    S2Forum Extremist
    • Jan 2011
    • 1342
    • Country: Scotland

    #1

    Early 3B rear bolts (M12)- NLA?

    I put in an order yesterday of a bit of a rear suspension refresh and everything was available except the rear hub>strut bolts that they said were 'discontinued without replacement in 2007'

    Mine are the early M12 type and the part number I supplied them matched the number they thought it was - N 10206501.

    Any advice?
  • Rusty
    Super Moderator
    • Jun 2004
    • 18953
    • Country: United Kingdom

    #2
    They're nothing special, just need the same spec and roughly the same length bolt with 2 washers and a nylock per bolt. Will cost about £1 for the lot at a local fasteners supplier
    Cheers'en, AndyC
    1994 ABY Coupe - Projekt Alpinweiss

    Comment

    • caterpillar
      S2Forum Fiend
      • Jun 2004
      • 2480

      #3
      use the 12,8 strenghts... not 8,8 verson...AND there are possible to drill up to m14 too...

      Comment

      • Rusty
        Super Moderator
        • Jun 2004
        • 18953
        • Country: United Kingdom

        #4
        Be careful there, using a different tensile strength bolt means using a different tightening spec as they're stretch bolts...
        Cheers'en, AndyC
        1994 ABY Coupe - Projekt Alpinweiss

        Comment

        Working...