B4/A4 Rear axle mounting bush removal/ install

[Vorsprung durch Technik]

I am thinking about changing the rear axle bearing mounting bush on our Dec 2000 fwd A4 tdi rear suspension and looking at the options of whether to buy a tool/tools to remove and install the bearing bush or just get someone reasonably priced to do the job for me.What should i be paying for labour to get the 2 mounting bushes changed. I understand it's a 2 hr job for a pro but correct me if i am wrong. So i am weighing up the pros and cons.If i had a tool then i could also do the 80 2.6 Avant rear axle bushes if that need ever arrises.

The bush in question is no 11 in the diagram.
Your thoughts and ideas appreciated.

[Monkeymagic]

I've done loads On mk4 golf based platforms. I cut/hammer the old one out and refit with poly therefore no special tool needed. Takes 3 hours as long as pivot bolt isn't seized

[Vorsprung durch Technik]

anyone else?

[Monkeymagic]

Do you want me to look up the vag tool number? Will that help

[Vorsprung durch Technik]

Thanks steve,that would be an idea!That was what i was hoping for, ideas on removal and also the various tools that could be used.I had a look on ebay and found this Franklin tool which is dear but might be a good tool.



http://www.ebay.co.uk/itm/1408401528...%3AMEBIDX%3AIT