AAJ Gearbox compability to 3B

[Arvidsson]

Hi! I know this has been disccused before, but are there anyone one with a little "btdt" insight on fitting a AAJ (200 Tq) 4.11 non-torsen box to a 3B S2 ? propshaft length? driveshafts etc? any info is appriciated

/A

[caterpillar]

it will fit in the car,and the engine.the inner joint may have other dia:its easy to change.the gearlinkage arent the same either.you will have to use the older one.
the length of propchafts,you will have to try and fail.....there are saveral different ones,the front propchaft are in 3 peaces,so you may fix your one,with the outer joint,with some senter axle,and the inner joint....

[Arvidsson]

it will fit in the car,and the engine.the inner joint may have other dia:its easy to change.the gearlinkage arent the same either.you will have to use the older one.
the length of propchafts,you will have to try and fail.....there are saveral different ones,the front propchaft are in 3 peaces,so you may fix your one,with the outer joint,with some senter axle,and the inner joint....

Ok! knew about bellhousing and gearlinkage, seems like no one`s sure about the prop.shaft....will just just have a look at it as you say...thanks for the info though!

/A