drive shafts

[palles2]

help!!!

i just bend 4 driveshafts in 500 km, any one nows were to get thees for drag use???

[AnLe]

which ones goes?

I have seen audis motorsport driveshafts (or is english for halfsaft?), and what we could see on it, it was just std shaft but the ends are drillet out to make it pipe, you can see trough of it, and outside was 1-2mm taked down, this makes shaft lighter and storger, becouse it can bend little without cracking, no welding seam bump in the middle, pipe is allways better than rod.

Of course it doesnt make then bulletproof, you may need some specially made ones..

[palles2]

att annlee

the ones in front,

you now were to buy theese you ar talking about??

[AnLe]

Do you mean the lightened ones? I'm planning to make a set next week.

or the specially made:
There is one Finnish firm that makes good shafts, http://www.sorvaamokarpiola.com/yhteydenotto.html
but I think there should be someone near to you?

or could fixit or tractive in Sweden help you.

[caterpillar]

spec shaft for audi

http://www.dione.se/ this firm do SPEC shafts.....!!

[palles2]

i dont understand a word on the finnish side, and sould not find anything about it on the swedish site!!!!!!

[caterpillar]

propshafts

palles@ you have to call them. or sendt them a mail.....i KNOW they make avesome propshafts

[AnLe]

And I have no clue, does the Finnish company international orders or are there anyone that speaks english or other foreing.

If there is not local suplier, Swedish companys are much easyer to you than Finnish.

[palles2]

is it anof just to change the driveshafts or shuld i change the cross too (dont now what they are called in english)