Does anybody know what a good price for a 3B clutch is?
-
-
OEM or Race spec?
Clutchnet or Sacs should cost around £300 - £350 with Pressure plate iirc.
Contact Alread hes normally got some in stock.91 S2 coupé - RIP
98 S8 - Luxury barge -
I've just put a std LUK clutch im my 3B, clutch was £180 and it cost me £150 to have it fitted. The clutch came from GSF and thanks to Clive I got 10% off
The car has a chip in and runs around 1bar boost, the clutch is coping fine so far. It's a shame I can't say the same for the slave cylinder that was fitted at the same time. Always listern to Uncle Corey when he tells you not to fit a pattern cylinder as they are crap, because he is right
sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racerComment
-
Sounds a very reasonable price from Quattronics. ****** about the slave cylinder though
Comment
-
When you say just, how long do you mean. I was on the phone to GSF in Bristol and Euro car parts and both told me sachs and LUK were out of clutches for 3B with no re-stock date!?!?Comment
-
It was about 3 weeks ago I got my clutchsigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racerComment
-
From Quattronics?
Kingdoms are run by Kings, Dictatorships are run by Dictators.
England must be a Country. :mischeif:Comment
-
I must be wrong then
I thought Corey had fitted the clutch and slave cylinder to AndyP's car with pre supplied parts by Andyp.
It's fairly obvious Andy bought the clutch from GSF as its in his post!
I'm guessing he bought the pattern slave cylinder from GSF or ECP tooI've just put a std LUK clutch im my 3B, clutch was £180 and it cost me £150 to have it fitted. The clutch came from GSF and thanks to Clive I got 10% offLast edited by s2dude; 15 June 2007, 21:27.Comment
-
Well I'm in two minds!
If I can find a clutch that can handle big power in the future and also not be a complete pain in the backside to drive in traffic then I might go for it ready for when I up the power abit.
However, I would be interested to know how much a standard clutch can handle in terms of power.Comment
Comment