Has anyone got a 5speed 3b box out at the mo. Need a measurement from the tip of the clutch slave cylinder pushrod to the bellhousing face on a 3b 5 speed box??
in mm please if poss.
-
Has anyone got a 5speed 3b box out at the mo. Need a measurement from the tip of the clutch slave cylinder pushrod to the bellhousing face on a 3b 5 speed box??
in mm please if poss.
Volcano ABY coupe
Ant -
I have a box out but I don't think the slave cylinder is attached
Martin Cutting
aka Keeper of "The Teutonic Kitten"
It's not better than sex, but it runs it a close second. -
(I'll have a look though...)Martin Cutting
aka Keeper of "The Teutonic Kitten"
It's not better than sex, but it runs it a close second.Comment
-
Volcano ABY coupe
AntComment
-
I've got the same problem, I've got 2 ARVs and a slave cyilinder somewhere.SSComment
-
I make it 106mm.SSComment
-
Oh poop! Well my slave cylinder wasn't attached - but I measured each item.
The fully retracted pushrod measured 151.5 from the tip to the hole centre.
The hole centre on the box measured 263.5 to the bellhousing face.
I make that 112mm?!!
Make of that what you will...Martin Cutting
aka Keeper of "The Teutonic Kitten"
It's not better than sex, but it runs it a close second.Comment
-
6mm diff. to above could that be that u measured the centers of the holes and not the faces? 3mm off each mounting surface either side if you get what i mean?
need to have a look at a slave cylinder. it's been a while since i've seen one. can't remember exactly where the bolt hole is.Volcano ABY coupe
AntComment
-
Got it right on the first one - and no, I didn't make that mistake with the hole centre! I've been there and done that with measuring stuff before!
....sadly none of this really resolves the difference
Martin Cutting
aka Keeper of "The Teutonic Kitten"
It's not better than sex, but it runs it a close second.Comment
Comment