Any Experience with Clutchnet???

[Billman]

Hi people,

do you have any experience with clutchnet clutches?

I was thinking about the 6 Pad Sinter sprung disc and the red 3x pressureplate.

cheers

[driftin jo]

Hi people,

do you have any experience with clutchnet clutches?

I was thinking about the 6 Pad Sinter sprung disc and the red 3x pressureplate.

cheers

S2 bo is not having a good time with one at the moment if that helps you .
link to his thread from a few days ago.

http://www.s2forum.com/forum/showthread.php?t=39409

[s2_bo]

Mine has just died after only 15k miles, not even driving that hard. Not sure yet where it failed yet, ill investigate that when i take it apart.

Other then that it was very very good, never slipped and not to heavy on the foot.

I had a st3 kit too.

[SteveH]

Unless you have the bucks for a Sachs organic, they're the best of the rest from my experience.

[DJones]

Hi people,

do you have any experience with clutchnet clutches?

I was thinking about the 6 Pad Sinter sprung disc and the red 3x pressureplate.

cheers

I have this combination fitted to mine, been as good as gold so far..

[Billman]

I wanted sachs race but they are very expensice compared to clutchnet.

[A80Avant]

go for sachs, you know it is better.

i think ill try sinter in the future.

[Billman]

Does anyone have the Clutchnet numbers for the clutch i am going to need? I am going to use single mass 7A flywheel.

I told them that it is an Audi S2 3B engine (same) and i gave them the Sachs Race part numbers. Hope they deliver the right one. Should i give them any specs (spocet tooth or something like this)?

[s2_bo]

How much did a kit end up costing you?

I think i will order another one too.

[Billman]

I am waiting for it to come and see if it is the right one. Then i am going to tell you. :-)

[Billman]

It came in today but the shipped a solid 6 hub sinter disc and not the 6 pad sprung i ordered.

Question is what should i do? I saw a post by repo saying that the non sprung one is better because of something i dont know.

What should i do? I am afraid that the non sprung one with single mass flywheel will make it hell to drive.

[Billman]

The disc has ca. 7mm thickness from the one side to the other (pad surfaces) and 23 tooth. Is this correct?

[Billman]

here are some pictures

[Billman]

The disc has ca. 7mm thickness from the one side to the other (pad surfaces) and 23 tooth. Is this correct?

???

[Billman]

Can someone maybe give me some specs of the original 3B clutch so i can check if i got the right one?

thanks