From what is this flywheel?

[spions]

From what is this flywheel?

[spink]

according to the number its off a 2.3 NG

[spions]

So it's even impossible to made it to fit on ABY

[spink]

I don't see why it would be,it looks very similar to a 3B(S2),bolt spacings are all the same.Out of interest could you weigh it,at a guess i would say it was slightly heavier than 3b.

[spions]

Some say it is 7A
If lathes it it will fit on ABY?

[re2500]

Its should fit on an ABY no problem as it is, if you fit a 3B clutch, remove the bellhousing spacer (in between engine and gearbox) and replace all the bellhousing bolts and dowels with ones from 3B/7A/NG.

[mcandmar]

Its from a non turbo motor, 7A, NM, NG etc. Same as 3B but heavier.

[kwlw]

Its from a non turbo motor, 7A, NM, NG etc. Same as 3B but heavier.

But it has timing pin. So it should be 7A/NM. My NG flywheel lacks timing pin. I know few guys, who successfully used it with AAN engines, however ABY has some sort of weird things like gearbox spacers which can make a mess . Dimensions should be same as 3b, however it is heavier like it was mentioned before.

Sau

[spions]

So where i can take of this not needed weight and edge?

[mcandmar]

On the back side of the flywheel, pics attached of a 3B version.

[spions]

I mean not on flywheel,but person or service-garage....

[spions]

Can someone tell me where I can lathe flywheel?
And how much it cost?
In UK.

[K Simmonds]

Any half decent machine shop will be able to do the job, bear in mind you should get the engine rebalanced if you use a flywheel different in mass to the original.

[spions]

I think flywheel need rebalanced
And where i can rebalanced it?

[K Simmonds]

Again, any half decent machine shop will be able to both lighten and balance a flywheel.