Where are these best to buy? Either oem or good quality spurious. As I'm in the process off getting ready to replace the two subframes on my 90 With some I have refurbished. I already have a the poly rear diff mount but am looking replace the front mounts and gearbox mounts aswell with rubber when I'm at it as getting solid sub frame mounts
-
-
Bump , anyone? -
Im currently in the process of replacing my diff and gearbox mounts with 034 track density mounts. Which are quite stiff but not solid. If they are too hard you could get 034 street density which are only slightly stiffer than standard. I also have solid subframe mounts and poly wishbone bushes.
Id recommend fitting a better subframe mount and bush at the same time, which is dead easy. Just because you probably wont get the full benefit of good gearbox mounts if your engine is flopping about all over the place
Black B3 1990 CQ 2.3E converted to ABY & 6spd. (301bhp) - Now Sold
03 Dolphin B6 S4 Avant LPG - New Daily Wagon
01 Silver D2 A8 3.7 quattro sport - SOLD
"Difficult is worth doing"Comment
-
Dont know if want go full on, as currently the plan, setup, is, alloy subframe mounts, poly wishbone and the new bushes for the rear tierods, 22mm RARB and set uprated spring from the Q forum group buy, so I'm currently thinking might have enough harshness in her. However if the street density ones arrant too dear might get them, as I'm still young and enjoy rock concerts and rough car is still a lot smoother
Comment
Comment