UrS4 front Inner cv joint tool and size

[Knight Rider S4]

[Nuvo]

That is they.

[Knight Rider S4]

@Steve, Polydrives and torq are different to xzn/triple squares. Torqs look a bit like a staggered cross head, polydrives have 6 points and are more commonly called Ribes.

http://www.ecstuning.com/Audi-C4_S4-...eshaft/ES9011/

[Nuvo]

@Steve, Polydrives and torq are different to xzn/triple squares. Torqs look a bit like a staggered cross head, polydrives have 6 points and are more commonly called Ribes.

[Algernon]

Thanks everyone for your help.
I know what to look for tomorrow now.
I figure it'll be an 8 as a 6mm allen key was smaller and a 10mm was larger when I used them to size them earlier.

[s2driveruk]

hmmm actually does ring a bell, think i ended up buying a set of laser tools to remove the inner cv's from the rear diff

[Knight Rider S4]

I would call that a 12pin torq/polygon socket (8mm)

[Nuvo]

Yep, they are xzn/triple square. 8 or 10mm, I can't remember which. Most probably 8mm as Goodall suggests.

[goodall]

always been 'xzn' size 8 as far i'm aware, i find best to use the air wrench as stops the shaft turning and they tend to be torqued

[Algernon]

They look like they'll need a triple square bit like this to me:

They have far too many points internally to be a torx type. Just need the size.

[s2driveruk]

yup torq i think too if like the rear diff

[Knight Rider S4]

I'm going to be removing the 6 speed manual box out of my UrS4.
I thought the inner 6 bolts holding the front drive shaft cv's to the box looked like an allen key would get them off.
On closer inspection they look like they're splined internally with too many points for a torx drive.
Am I correct?
Are they a splined internal fit? If so does anyone know what size I need to buy.
Please feel free to tell me I'm a doofus and they are a torx fitting and in what size if that's the case.
Ta in advance.

Torq the last time I looked ...take em off tap with a hammer and its off

[Algernon]

I'm going to be removing the 6 speed manual box out of my UrS4.
I thought the inner 6 bolts holding the front drive shaft cv's to the box looked like an allen key would get them off.
On closer inspection they look like they're splined internally with too many points for a torx drive.
Am I correct?
Are they a splined internal fit? If so does anyone know what size I need to buy.
Please feel free to tell me I'm a doofus and they are a torx fitting and in what size if that's the case.
Ta in advance.