quick hub question

[vcosmin]

I need some info, i have a b4 quattro and the rear hub 4x108, and smaller, bearin 77mm, or so, is there a compatible rear hub, with 4x108, and bigger bearing, like s2 (82mm), which will allow the s2 rear driveshaft to be used? i know that all avants quattro, have it, but they are hard to find here.

[vcosmin]

Update, posible combination, is rear hub from avant quattro - with 82mm bearing, question, is RS2 rear driveshaft, and avant quattro rear driveshat the same ?

8a0 501 203 lx - is rs2 code


8a0 501 203 lx - avant quattro code ?

[Skull]

you have the 75mm bearing. V6 quattros, S2 and RS2 have 82mm bearings.

therefore, you have to find V6 quattro (limousine/avant) hubs and housings. the fronts are good from a coupe too (V6 or 2.3 20v).

[Jamo]

I have Avant hubs for sale

[vcosmin]

you have the 75mm bearing. V6 quattros, S2 and RS2 have 82mm bearings.

therefore, you have to find V6 quattro (limousine/avant) hubs and housings. the fronts are good from a coupe too (V6 or 2.3 20v).

are you 100% as etka does not list them as 82mm , only avants quattro, all models, are 82mm ? one more thing all models are 4x108 , beside s2 wich are 5x112 ?

[vcosmin]

I have Avant hubs for sale

I know, but probably the shipping will cost a lot, plus i found an 80 sedan v6 quattro here in my contry, i might use the driveshafts to, if it are the same as the s2 ones.

[Skull]

all b3 and b4 over 150hp have the 82mm bearing, so... the avant and limo are the same cars. the differences are only cosmetic.

[Skull]

ETKA says im wrong, maybe i am. but again, there is no difference in the avant or limo hub housings...

[vcosmin]

ok, but the hub are still 4x108 ? as i have already new, discs , wheels, etc, allaround

[Skull]

yes. only the s2 and rs2 have 5 bolts.

[vcosmin]

ok mate, 10x, hope it will work ok, as the 101% standard 80b4 driveshaft will not hold over 600awp

[Jamo]

Shipping depends where you are, can be brought down to sensible levels they are there at the moment if not snapped up before Good luck!

[vcosmin]

Just an update, dont know why, but desassmebled the rear hub,but this b4 v6 uses the same driveshaft, rear hub, rear bearing, as the b4 2.0, i mean the smaller ones, with the 75 mm bearing, on the other side, the reaer diff is good ratio for the o1e - 4.11