CV joint info

[terrybullwon]

Any one have to hand the size and spec of the inner CV boot with bolt hole PCD?

Cheers James

[quattro84]

It's time for a sticky for all the CV joints used on the S2 with aftermarket supplier & part nr. if you ask me.

[terrybullwon]

Can any one confirm please?

Total Diameter
Bolt Hole PCD
Boot Diameter
Bolt Hole Diameter

[jade]

Hi

Send me your email and i will email a photos with sizes, Just changed mine yesterday

used Febi Bilstein kit comes with every thing bolts clips ect inner is about 12 Pound Very commonly used on A4 A6 Vw

Febi Bilstein part numbers

01171 Think this is the inner, Other the outer

03636

Regards

[Error404]

I know the rear inner ones use a 108mm PCD bolt holes into the diff flange, CQs use a 100mm PCD, both M10 bolts.
Prop CVs use an M8 bolt. I have some in the garage i'll have a meaure up ove rthe next few days

Are you looking at some of the snazzy motorsport spec ones from TRW and the like?

[Error404]

Here you are mate, found these diagrams on my travels

S2 / CQ20v Front Outer CV


S2 Front Inner CV

[GazzaG60]

not sure on the exacts but the t35 vw transporter uses 108mm inners with the splines to match VW G60 shafts. need to compare the teeth for compatability.

the vw transporter can be used for 6 speed conversions on stock splined shafts for vw golf/corrado etc.

not sure if this is a waste of a post or not. ill try to dig out the set i have for comparison.

[terrybullwon]

Alex I forgot to tell you how much I love you for this any one got a diagram of the rear??

[driftin jo]

Just measured gearbox output flange PCD is 94mm dia of joint is 108mm

[terrybullwon]

Nice I'll put that against the Audi sports CV's I have here from A imsa

[driftin jo]

just checked the rear diff to make sure it is the same as the gearbox, it is,
94 mm PCD 108 dia, well this is an Avant rear diff but I assume the coupe is the same.

[Error404]

yup the joints are the same

[AndyP]

Anybody know where to get OE GKN CV joints for the propshaft?

[Error404]

Does Pete @ QC have them? I think he had the Lobro (GKN) driveshaft CVs last time I spoke to him