I have a tdi 01e from 1992ish a6 quattro, (AAT5cyl block)
the propshaft output has a major wobble/bend
andy10v has offered me a o1e from a 1992 a4 quattro (1.8 tdi) as a donor/replacement (it has problems selecting 6th) which was good of him
final drive =3.89
my a6 one=4.?? standard s2 ratio?
my initial plan is to strip both rear ends and see if the a4 prop output will fit the a6 box,hopefully shaft size, bearing, spline, length or whatever are the same however from the outside they appear different. the a4 one is smaller like o16, o1a and has that big rubber donut round it. the a6 one is much larger and is not surrounded however bolt holes look the same?
does anyone think parts are interchangeable or is the final drive difference a factor?
info much appreciated!
the propshaft output has a major wobble/bend
andy10v has offered me a o1e from a 1992 a4 quattro (1.8 tdi) as a donor/replacement (it has problems selecting 6th) which was good of him
final drive =3.89
my a6 one=4.?? standard s2 ratio?
my initial plan is to strip both rear ends and see if the a4 prop output will fit the a6 box,hopefully shaft size, bearing, spline, length or whatever are the same however from the outside they appear different. the a4 one is smaller like o16, o1a and has that big rubber donut round it. the a6 one is much larger and is not surrounded however bolt holes look the same?
does anyone think parts are interchangeable or is the final drive difference a factor?
info much appreciated!
Comment