Is there a locking pin in the front driveshaft? I have slight play in the o/s/f driveshaft and there is no play in the n/s. Is this due to a clip or pin missing?
Need help
Need help
-
-
Has it been removed recently ?
There is a cup washer that needs to be fitted a specific way...
PaulPaul Nugent
Webmaster http://S2central.net
Administrator http://S2forum.com
1994 S2 Coupe ABY - aka Project Lazarus
2001 A6 allroad 2.5TDi - family tank
2003 S4 Avant 4.2 V8 - daily burble
Purveyor of HomeFries and Exclusive agent for Samco hose kits (S2/RS2)
There are only 10 kinds of people that understand binary - those that do, and those that don't
-
Not sure if S2 is different from typ85, but mine was loose recently. There is a bolt that goes through the centre of the driveshaft holding it into the gearbox. Mine had come completely undone.Originally posted by Habib
Hope this helps?
ChrisLast edited by jogi730; 9 December 2004, 23:17.Audi 90 quattro (Typ 85)
20v turbo conversion
sigpicComment
-
I was wondering how they are connected to the gearbox, mine is making all sorts of strange noises from below the front passenger footwell. Either that or a collapsed bearing
Comment
-
Where is that cup washer located?Originally posted by S2central.netComment
-
Does anyone know where the cup washer is located?
Need to get the car out the garage for the meet tomorow.
HabibComment
-
There is a cup washer with the outer cv joint but no washer with the inner cv joint or the flange shaft (atleast MY92 and up, older one's could be different). The flange shaft is attached to the the gearbox either with a center bolt or with a spring ring. According to my akte CGR-box has a center bolt, others have a spring ring at the inner end of the flange shaft.Last edited by JariP; 12 December 2004, 12:19.Comment
Comment