Will S4 B5 front drive shafts fit S2 Avant?

[V6quattro]

My front drive shafts are bent. Now i can get a set off front shafts from a B5 S4. Does somebody know if they will fit?

[caterpillar]

dont think so: different chassi size

[nip]

My front drive shafts are bent. Now i can get a set off front shafts from a B5 S4. Does somebody know if they will fit?

do they vibrate through the car when there bent?

[V6quattro]

No. Just a little vibration in the steering wheel at high speed.

I'm trying to upload a short movie to show how bent they are.

[V6quattro]

2 short movies on how thy are bent.

[quattrostyle]

Video no worky over here (again)

[V6quattro]

http://youtu.be/dIOrYgDuAvo

http://youtu.be/boKrspeCIm0

[rynaqui]

That looks bad..don't drive the car till you get this sorted or you may cause more damage

[V6quattro]

I know yes. Anyone know its common for S2 avant front shafts to bent? Running around 600hp and 700Nm??

[quattro84]

http://webshop.cp-service.se/en/driv...-audi-rs2.html ?

[V6quattro]

http://webshop.cp-service.se/en/driv...-audi-rs2.html ?

They are nice but a little to expensive for my.

Was looking at this one's. But they are B5 S4 one's so i don't no if they will fit.

http://www.jayracing.com/driveshaft-shop-c-15_252_253/driveshaft-shop-audi-s4-b5-chassis-199852002-1000hp-front-axle-p-8070.html

Or maybe just try these. As you can see the OE S2 shafts are bent on the hollow part and this are solid shafts. But again B5 part.

http://jhmotorsports.com/shop/catalog/front-cv-shaft-complete-joints-new-for-b5-a4-p-120.html?cPath=21_62_63_125_213

At that price you will expect the break immediately but who knows

[quattro84]

JHM is okay stuff. Not a lot to go wrong on driveshafts as long as the splines are matching the CV joints... maybe give Coen Donkers a call or a visit to check the difference in lenght?

[V6quattro]

Already did some research and the splines on B5S4 and S2 Avant are the same. I will sent JHM a mail if they can tell my what the lengths off there solid shafts are.