I'm going to install a Sachs SRE clutch to my 3B over the Christmas break, I want to fit a new release bearing while I'm in there as well as a new slave cylinder. What brand bearings are considered to be the best quality, OE Audi?
-
1990 B3 2.0 80 quattro.
1992 C4 2.8 Avant quattro
1994 MTM RS2.
1998 B5 TDI quattro Sport.
2000 B5 TQS. -
Well I fitted a metal faced INA one and it's rattling like a mother ****er after 1500miles putting up with the SRE pressure plate. So I don't recommend that for a start!Panthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 Avant -
Has anybody tried the SRE one? £40 v £20 for a standard sachs one seems like good value for money if it holds up (I would hope so running a full SRE plate, disc and throw out bearing?Current-2004 Impreza PPP wagon
Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
Sold ABY-stockComment
-
Didn't even know three was an SRE one or I'd have bought it
My INA one was about £35 IIRCPanthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 AvantComment
-
1990 B3 2.0 80 quattro.
1992 C4 2.8 Avant quattro
1994 MTM RS2.
1998 B5 TDI quattro Sport.
2000 B5 TQS.Comment
-
Current-2004 Impreza PPP wagon
Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
Sold ABY-stockComment
-
Nice one, thought it might be from those guys again.
Say's limited supply and to phone first, might just order one and see what happens.
1990 B3 2.0 80 quattro.
1992 C4 2.8 Avant quattro
1994 MTM RS2.
1998 B5 TDI quattro Sport.
2000 B5 TQS.Comment
-
I'm running a stock sachs one with my sre clutch. Ok so far.Comment
-
So am I and it had done 50k miles before I put the new SRE clutch in.
I was going to get a new one when I did the RS2 set up but forgot to buy one
and only realised when I when to put the engine back in. I couldn't be bothered waiting
so I just went with the old one, 10k miles later and its still fine.Comment
Comment