Wagner Short intake wiring solutions

[newsh]

Show me your pics of wiring routing, I'm trying to work out a neat way to route the extended wiring.

[denniselbows]

heres mine it the best pic i have for the moment may be able to get a better one later for you

[QuattroFever]

i ran mine along the strut brace and down the right wing.

[cooperquattro]

heres mine it the best pic i have for the moment may be able to get a better one later for you

same as mine....how do you rev it with that throttle cable??

[A80Avant]

In mine, only the Throttle cable stayed on top. All the rest went under the IM along the level of the water collector

[newsh]

In mine, only the Throttle cable stayed on top. All the rest went under the IM along the level of the water collector

Thats what I'm thinking.

Also thinking I might try spacing the throttle body down to clear the bonnet

[A80Avant]

how are you going to do that?
i actually used the phenolic spacer to reduce the heat transfer that the IM causes, roducing heat soak to the IAT sensor.

[quattroamm]

what throttle cable is used with the wagner intake

[newsh]

I have the spacer I made when I fitted the RS2 IM to the 3B, something I read in another thread this morning made me think of it, IIRC its 20mm though..

[newsh]

what throttle cable is used with the wagner intake

On RHD cars you need to extend or make one up, check the sticky in the Wagner forum

[A80Avant]

i see

i had a huge improvement over the IATs though with the 034 phenolic spacer, as on every stoplight the inlet temps did not rise as much, robbing off timing and perfomance! I couldnt get away with modifying the hood though, but its ok.