RS2 cam pulley, camshaft. Question

[luki95]

Hi,
engine in my RS2 was rebuilt but i have troubles with idle. https://youtu.be/AfVgNEXuX-U https://youtu.be/uqtBXBDgeHI (Hard to get it on camera)
I am running ABY timing belt and water pump
From the beginning, when I bought it, it had a timing pulley without the "b" mark
When i set the crank pulley to the marks, mark at cam shaft pulley hit the mark on valve cover BUT camshaft dots looks like this:
"IMG-2161.jpg
"IMG-2151.jpg
IMG-2159.jpg
IMG-2146.jpg

When i set camshaft dots to be aligned it looks like this:
IMG-2165.jpg
In this situation marks at camshaft, crank pulley are moved to the right:
IMG-2163.jpg
IMG-2162.jpg

My question is what i need to do to get my timing right ?
- Buy RS2 cam pulley with "B" stamp ? or stay with normal pulley because i am using ABY timing kit ?
- align cam shafts ?
- Stay with ABY timing belt and pump ? or change to RS2 ones ?

Thank you for advices
Lukas

[s0_big]

I think you have put the intake camshaft one tooth wrong on the chain.

[luki95]

I think you have put the intake camshaft one tooth wrong on the chain.

Thank you for replay
I remembered at your RS2 thread you have same problem ? I was looking for this post at your thread today but couldn't find it

[s0_big]

I did that misstake. If you are running all ABY stuff everything should line up correct. In your first pictures all seems good, except for the marking on the inlet camshaft.

[luki95]

Can you tell me also do i need RS2 cam shaft pulley ?

[s0_big]

This is how your camshaft markings should look like. 45764-86bf3eacfe77dcf23947aabc16efc42a.jpg

[s0_big]

Can you tell me also do i need RS2 cam shaft pulley ?

No you dont.

[luki95]

No you dont.

Summarizing:
When i am running ABY cam pulley i have timing like normal S2 no change to opening and closing points ?
When i am running ADU cam pulley even with ABY timing kit i have 10 degrees change in timing due to changes in pulley ? i am setting timing on marks because of 29 teeth water pump ?
When i am running fully ADU set i have 10 degrees change in timing and i need to go half tooth of the mark on cam pulley because of 26 teeth water pump ?