RS2 bonnet grill

[sailaz]

Maybe somebody could post photos of front bonnet mesh holder/frame 8A0 854 641 3FZ inside part and the bonnet inside how this frame is attached to the bonnet ? Can't figure out how this frame has to be secured to the bonnet
I do have those OEM clips to secure mesh to the frame
8A0 853 645 A x 4
8A0 853 646 A X 3
but I have a feeling that something is missing on the bonnet lower part, I mean for the frame lower part to secure.....
I suspect that I'm missing 4x clips 4A0 853 645 A

https://webautocats.com/etka/audi/rs2/41/853030
https://webautocats.com/etka/audi/rs2/41/823010

[Nuvo]

The clip you have pictured in the third picture are completely the wrong type, I think they are used on upholstery parts.
Have a look at the following thread, it should give you some guidance.
https://www.s2forum.com/forum/techni...ip-information

[sailaz]

The clip you have pictured in the third picture are completely the wrong type, I think they are used on upholstery parts.
Have a look at the following thread, it should give you some guidance.
https://www.s2forum.com/forum/techni...ip-information

Thanks Nuvo,

The clip ( 4 of them ) in the picture is from bonnet mesh/grille assembly by ETKA, No.15:

https://webautocats.com/etka/audi/rs2/41/823010

and it is shown in the link you have provided:

https://www.s2forum.com/forum/techni...444#post562444

on the right side.

and as I have mentioned:
"I do have those OEM clips to secure mesh to the frame" ( those two positions above No.15; and as per photos in your link )
8A0 853 645 A x 4
8A0 853 646 A X 3

frame and mesh has been installed, was a bit complicated to secure those 7 clips as couldn't find proper screws so came to the solution to use plastic fixings 10x5x16
10x5x16.jpg