Project Binky

***Greg_S*** · 4 November 2018, 21:47

Originally posted by Error404

Nice bit of engineering there for the remote accessory drive

Those flexi-shafts are crazy expensive in high torque/rpm applications

Maybe its just me, but I am disappointed with the wiring job.

Yeah I thought the same on the wiring. I was expecting it to be wrapped at least.

**PRY4SNO** · 4 November 2018, 23:38

Funny you guys mention the wiring as I was surprised they fed the looms through the frame with care, then didn't install a grommet to protect the insulation from vibration. Thought it was a tad peculiar given the extent they go to on brackets,etc.

At any rate, this latest edition usurped my favourite episode (the heater box) as the "they'll never top that!" episode.

**Bowie69** · 4 November 2018, 23:44

I'm sure it will be wrapped, it just isn't finished yet...

**irishs2** · 5 November 2018, 12:34

I am sure the wiring comes out again when car goes for paint. They had no grommets but addressed that at the start of the video.What an amazing alternator solution.