best chip and exhaust s2 avant???

[AUDIS2avant]

As above, whats your experience?
Should i get just cat back exhaust or compleet, and i dont want it to be noisy as it´s my eweryday car
And chip, is there 2 inside? seem to have read about it somewhere?
Recomend anyone?

All is for an 93 s2 avant with aby engine.
Thanx

[urquattro-island]

a

full system is always nice, yes there is two chips inside..

[Azman]

For a chip speak to S2central onthis forum for a homefry only good reports on them.

Exhaust get one made to your spec. I have ben quoted approx £850 for a little louder with one sports cat turboback

[Jonas_R]

You have one boost chip and one fuel/air chip.

If the car has not been chipped before, then you most likely need to solder out the chips and put in sockets.

I would also recommend S2central.net (Paul) homefry, it is a really good generic chipset.

[Rusty]

Third plug for homefries. I have a full system, 3" down pipe, sports cat and single silencer at the rear. It's not that loud because from where the centre section should be to the rear box it's made from 2.5". Makes a nice noise on full throttle but is sensible on cruise. If you get a bigger intercooler then you'll get great results off that setup.

[M_GORDON]

You must change the MAP to.
We have one of 250KPa and with this chips we must put RS2´s MAP, the MAP of 300KPa

[Jamo]

You must change the MAP to.
We have one of 250KPa and with this chips we must put RS2´s MAP, the MAP of 300KPa

No you do not for a homefry chip, geez

The 300KPa MAP sensor is required if you want to run more than 1.5 bar

The homefry runs at 1.4 bar

S2central you really should trademark "Homefries"

[kinex]

for an stock audi s2 3b engine how much the power/torque increase would be after Paul' s chip ? And along the chip what parts should be replaced/upgraded for to get full potential from homefries™ thx in advance.

[Rusty]

It's 21 PSI so 1.5 Bar on the latest version, dropping to 0.8 Bar at the red line. I've got a boost profile in the gallery section...

[Jamo]

At present the homefry is ABY / RS2 only

I know a 3B version is in the making

[Jamo]

It's 21 PSI so 1.5 Bar on the latest version, dropping to 0.8 Bar at the red line. I've got a boost profile in the gallery section...

21 / 14.5 = 1.44 = 1.4 bar :mischeif:

[Rusty]

HPMuirt is running Homefries on a completely stock car and got 270bhp (IIRC) at the 07 Weston RR day. With a cat back exhaust, Samcos and a modified airbox I got 294 on a RR where most chipped S2s were 270-280bhp on the same day. Several have seen around the 290bhp mark on Homefries with a decent exhaust.

3B wise you can go to MRC and get a chip from them.

[kinex]

Jamo, i ll be waiting for that but would'nt some parts (exhaust, wastgate spring, ingnition coils, bigger intercooler maybe etc.) help a bit after installing a 3b homefry chip ? cheers.

[kinex]

Andy, i havent saw Mihnea around and its less prolyly for me to travel in UK, but thx for reply i guess i got my answer now.

[Rusty]

MRC will do your chip by post