Rs2 homefry

[david]

Yes to be honest have had thoughts about fpr and rs fuel pump etc but did some searching on here and others seemed to be doing well on a fairly standard any setup ie no rs air box or updated exhaust

are you using rs2 ecu or ecu s2?

[andyg plym]

S2 ecu with 3 bar mrc v map

[prj]

you will not see 1.9bar with v-stream chips

I wonder why, because that's what the boost is set to in those.
If it's not making that, then search for faults with the car.

[david]

S2 ecu with 3 bar mrc v map

then something is not quite right with your setup,1.5bar is just too low for mrc high boost map.
do you know if the resistor was changed while 3 bar map sensor was instored in ecu?

[andyg plym]

Yes boost leak check needs doing that on itself will improve mpg

[andyg plym]

then something is not quite right with your setup,1.5bar is just too low for mrc high boost map.
do you know if the resistor was changed while 3 bar map sensor was instored in ecu?

In all honesty unaware of which resistor is being referred to I was under the impression that chips with 3 bar map would do the job....problem I found was that there wasn't that much info on here for the rs home fry.....

[prj]

In all honesty unaware of which resistor is being referred to I was under the impression that chips with 3 bar map would do the job....problem I found was that there wasn't that much info on here for the rs home fry.....

They won't.

[andyg plym]

They won't.

Right so what am I missing in this setup ? Or is the rs home fry not that good ?

[prj]

R201 -> 5.6k

[andyg plym]

R201 -> 5.6k

What is this ? Resistor ?

[david]

What is this ? Resistor ?

that's what you need to run rs2 software

[andyg plym]

No idea about that I must say, anyone know where I can get one ? Cost etc ?

[david]

No idea about that I must say, anyone know where I can get one ? Cost etc ?

prj is your man

[johne]

No idea about that I must say, anyone know where I can get one ? Cost etc ?

Maplin, 10p or so. Cost isn't the issue, it's if you've got the confidence to open the ECU and fit it.

John

[prj]

Probably not a very good idea to attempt this yourself if you have no SMD soldering experience...
There are better places to practice than a 150+ quid ECU.