Hey guys, I am half way through changing the clutch on my urs4. Wasn't slipping just yet but pedal was getting heavy and grabbing on the last 10mm at the top of the pedal.
So g/box out, im looking at the pilot bearing. Do i have to remove the flywheel to get the bearing out? I was hoping to hydraulic it out with some grease but have noticed a small hole in the flywheel cavity. Have seen some pictures of flywheels on the net that show a cap on the back of the flywheel with the small hole in it. So do you have to pry that off to drive the bearing out? Hope that makes sense..
Thanks in advance Kevin
So g/box out, im looking at the pilot bearing. Do i have to remove the flywheel to get the bearing out? I was hoping to hydraulic it out with some grease but have noticed a small hole in the flywheel cavity. Have seen some pictures of flywheels on the net that show a cap on the back of the flywheel with the small hole in it. So do you have to pry that off to drive the bearing out? Hope that makes sense..
Thanks in advance Kevin
Comment