My S2 - 1 of 306

[UrS4boy]

There should be some clues in that S2 Sedan pdf that I sent you.

Like this:

[UrS4boy]

Location of front and rear UrS badges

does someone know, where it was originaly at the back, dimension from end off bonnet

Because I haven't been lucky enough to see an S2 sedan in person, all I can offer is this info from the UrS4s that I have:

Positions are as follows:

Front = uppper edge lined up on middle bar grill, badge is 42 mm (or so) from chrome grill trim. (EDIT: S6 turns out to be the same, 42 mm from the lower outside edge of the badge to the edge of the chrome trim (when in the correct vertical location (top edge in middle of the S6 grill height))

Rear = lower left corner 22 mm from left edge of trunk lid (93, 94). Presumably 92 = upper right corner = 22 mm from right edge of trunk lid.
Rear = lower edge 15 to 16 mm above lower edge of trunk lid

Those came from my 93 UrS4 sedan. I just went out and measured the location on my 94 S4 V8 avant and the distance from the edge was 18 mm not 22. The distance from the bottom was slightly less than 15 mm.

There should be some clues in that S2 Sedan pdf that I sent you.

Location of front and rear UrS badges

http://forums.quattroworld.com/s4s6/msgs/18657.phtml

Just for fun:

[Nace20]

Changed steering wheel today



it feels complete diferent car

and ordered all 3 S2 badges, hope to get them till weekeng

does someone know, where it was originaly at the back, dimension from end off bonnet

[UrS4boy]

the avant and limo have the battery there...

Yup.

[rxl]

3b coupes also have it under the. Back seat. Lhd that is.

[Skull]

Should the battery not be under the rear seat?

the avant and limo have the battery there...

[Nace20]

only in coupe ABY

[quattrostyle]

Should the battery not be under the rear seat?

[Nace20]

i have put the interior together and cleaned it a little bit
I can't wash it, because we have below 0°C but have made some pictures with day light

[Norbert]

Best of luck !
Congratulations !

[Nace20]

it is close that now when i have remowed all extra wiring

[UrS4boy]

then i started inside, from a little microfone from GSm instalation i camed to this


it was busy day, but slowly i will get to the end

In case you were wondering, this is what that relay panel is supposed to look like:

[Nace20]

I have started day with inspection of the brakes, and i had luck, at rear, there was nothing left, only steel



i had home from s4 old pads and replaced them so atleast i can drive the car

then i started inside, from a little microfone from GSm instalation i camed to this









in the evening a friend came around and brought some parts with him





indicator that i didnt have



it was busy day, but slowly i will get to the end

[n33yo]

you really bought a great car

[Nace20]

so it is home

first 50km made, it need new brakes, they are realy rusty and maybe one bearing at rear and it should be ready for registration

overall i am suprised how good it drives,no noises from suspension ...



I will make better pictures tomorow