2.3 20v engine

[turbo20v]

hi!
well i have 7a 2,3 20v engine for sale. it is complete with all wirings and so.....
i prefer seling it complete but you could also ask me for some parts

for more info send me PM

thanks

[A80Avant]

if someone wanted a to use the 7A engine on a B4 chassis,what kind of transmittion could he accomodate,supposing that it is a front wheel drive?

[~Delta]

In a B3 / B4 chassis, any transmission will accommodate the 20V engine, as far as bolt - together goes.

Ratios vary, so it would help if you state what engine currently sits in your car?

[A80Avant]

the engine that sits in the car now is 1.6 with 101hp.transmittion is 5speed manual

[~Delta]

20V engine will bolt to current 5 speed tranny, but a bit low geared. Will accellerate quicker than a stock 20V, but maximum speed (academic anyway) won't be as good.

Ideally, a 5 speed tranny from 2,226/2,309cc (KV/NG) will be better.

[caterpillar]

7a in 1,6 compartment

7a and 1,6liter 4syl HAVENT the same boltpattern;sorry,have i told so ,its WRONG..... by the way,the 5syl arent mount at the same way ether.. the 4syl(exept diesels) have the mount on the gear/front end subframe ,the 5syl have the mount in the car ,at the innerwing,not in the subframe,and this enginemount arent a part you can by ,only take from a scraped car....and weld properly on!!!

[A80Avant]

Β4 1.6 does mount on the car and not on the subframe.Subframe mounting was only on the B3 typ89 car.

[caterpillar]

then you must have 5syl tranny to fit the engine

[A80Avant]

hey turbo20V how much is it for the engine and how much are the shipping costs to Greece(if it can be shipped)
cheers
Vasilis

[~Delta]

7a and 1,6liter 4syl HAVENT the same boltpattern;sorry,have i told so ,its WRONG..... by the way,the 5syl arent mount at the same way ether.. the 4syl(exept diesels) have the mount on the gear/front end subframe ,the 5syl have the mount in the car ,at the innerwing,not in the subframe,and this enginemount arent a part you can by ,only take from a scraped car....and weld properly on!!!

In B3 / B4 cars, the bellhousing was multi-holed - will accept IL4, IL5, V6 and V8 engines...

[caterpillar]

havent seen that...!