I got it today
thx for the fast delivery
tom
thx for the fast delivery
tom
-
-
Cool, a few other guys got their sensors as well and I have shipped out 2 more.
Please let me know how the install goes.
The shipping was just priority air mail, I am glad it got to you so fast!Comment
-
got it too.
cheers.Comment
-
Just tocomfirm that if i was running RS2 set up on my ABY this would replace my map sensor and act as a RS2 map sensor ok? If so can you PM me payment details as I would like one please.Last edited by Big Lee M; 9 August 2010, 20:26.
Just some finishing touches to do nowComment
-
Comment
-
Sent a couple more out and nemilosu already attached a sensor and posted some pics in his build thread.
Here is a picture showing his install, using one of the stock sensor mounts to hold the sensor in place:
Comment
-
EEEE....it was my plan too...Sent a couple more out and nemilosu already attached a sensor and posted some pics in his build thread.
Here is a picture showing his install, using one of the stock sensor mounts to hold the sensor in place:
Comment
-
and you must cut from original hose about 1 cm and the sensor will fit perfectly.Comment
-
It's still funny how it is possible to fit 10 of these instead of 1 Bosch sensor, because they are so small.Comment
-
-
Thanks for you quick service I got mine on Monday. Cheers.Just some finishing touches to do nowComment
-
Nice to hear
All others have gotten theirs as well.
I remembered something regarding the install...
First, as nemilosu said, you can just cut the stock hose 1CM, and it will fit.
Second, a friend of mine installed the sensor by using the pins of the 250kpa bosch sensor. He didn't care about the bosch sensor, so he just cut the pins off the 2.5 bar sensor, bent them and soldered them to the 3 bar sensor.Comment
-
-
Quite a few more sold, but I still have some.Comment
-
Can these be used in a 3B ECU, I take it no?1990 B3 2.0 80 quattro.
1992 C4 2.8 Avant quattro
1994 MTM RS2.
1998 B5 TDI quattro Sport.
2000 B5 TQS.Comment
Comment