3B brake servo

[driftin jo]

3B hydrolic brake servo, perfect working order, £40 + postage.

[lagz33]

Dont still have one of these do you?

[driftin jo]

I think so, I will go and check.

[driftin jo]

I have just checked the part numbers with KATE and she says 441 612 101B is the 3B
part number, the one I have is 441 612 099B, although I'm sure it came from a 3B coupé.

Can you read the number on yours?

[lagz33]

Will have a look, is it visible without removing it?

[LHD_Kid]

The newer and older versions are fully interchangeable, although you need to take care with connecting the correct pipes to the correct places - also, there are short and long versions.
It is also possible that the bulkhead will need a notch cut out to fit the alloy version if going from a cast one. But, there should be no problems.
Chris

[driftin jo]

I very much doubt that, it is on the bit that is on the inside of the firewall,
buried behind the dash. You may be able to get a photo of the number with
a small camera or camera on a phone.

[lagz33]

I will see if my mechanic friend can get a pic of it tomorrow evening. Im getting the brake system exclamation mark after two pumps of the brakes, anything else I could look at/replace?

[driftin jo]

Its probably your bomb that's dead in that case.
A lot quicker to change as well.

[PhantomS2]

I need this if lagz33 decides it is not required? Am I no2 in line ?