K26 turbo - 430 HP

[Albert]

I have for sale my used K26 turbo with cnc matched wheel.

It has done around 250 km after full rebuild. Still works as new. I have managed to have 430 HP and 507 Nm with this turbo. I went only for 1.5 bar and limit 500 Nm for stock engine with 7A cams.

It is ultimate turbo for stock engine, better than RS2 one, with aftermarket exhaust manifold (stock kkk k24 mount on manifold). Spools very good, there is almost no lag when the turbo is in the revs.

I'm only selling because I will have Pauter rods put in the engine during winter and want to put bigger turbo.

Price 495 pounds / 595 euro including shipping to Europe.

[quattrostyle]

What's up with the wheel on the hotside?

[Albert]

Tuned also. It is bad pic. Flash distortion

[Timon]

Can I have diameter's for hot and cold sides please?thanks

[Albert]

Cold side inside inlet diameter is 57 mm. Cold side size is standard. I have to make measurements.

[jax1]

This is not bolt on to Audi rs2 stock exhaust manifold???

[Albert]

it is bolt on stock k24 exhaust manifold (S2, RS2) But on standard S2 you wont get that much HP.

[jax1]

It's not that powerful like K26/27 turbo?

[Albert]

I have managed to pull 430HP but only on 1.5 bar because safe limit on stock rods ~500Nm. The turbo is very good for road car. No lag, fast spool. Should be good for up to 450HP but I can't promise.

[Jonas_R]

What turbo was this before you stuck in the CNC machined wheel?

[Albert]

This was stock k26 turbo

[Albert]

But the cold side was bored out to fitt bigger cnc wheel

[jax1]

it's not water cooled??

[Albert]

Yes

[jax1]

your modifications were only 7A cams when you got 430 hp?