building a sportquattro

[SteveH]

Looking forward to seeing you there

[Jeffer]

I noticed on the dyno that one axles was "slightly" bent.
So we went about it with the hamer. Man, that axle is solid . Couple of whacks did the job, sort of... Well it held the dyno abuse.

I probably bent it last year. Not this time on the dyno in any event.

[Kiko rs2]

awesome project Jeffer...bravo.....hope we'll hear thar beast soon

[s2_bo]

Awesome results so far Jeffers.
Looking forward to the retake on the dyno when you fit the new ignition!!

[Jeffer]

Just weighed the car. Its 1300 kgs with me in there (80 kgs) and a full tank of fuel.
Front weighs 760 kgs
rear weighs 540 kgs

Bit more then I expected. But still happy with that.

[andy10v]

How do you find the scissor lift to work on?

[Jeffer]

Andy this is the one I use.

http://www.buitelaar.nl/comasy/templ...productid=5391
Dont know the english word for it. Sorry.

[andy10v]

Andy this is the one I use.

http://www.buitelaar.nl/comasy/templ...productid=5391
Dont know the english word for it. Sorry.

Great, thanks.

How stable are they?

[Jeffer]

They are pretty stable. Never had a moments doubt it would fall over.

[andy10v]

Thanks

[Jeffer]

Ok, final bits are heading this way.

Faulkner springs, custom made to suit the SQ suspension
450 and 500 lbs/in
7 inch long springs

Sadly no AST dampers but Koni adjustables
Sport 86 2086SPD2

And new ignition CDI driver.

Bitburg 20th may is the first 1/4 mile run of this year.

[Bram]

Konis will work

[Jeffer]

Never used the Bram, so if you say so

[Jeffer]

Well the new ignition arrived. New dyno day is planned in 3 weeks . Exciting!

[zlobo]

Jeffry, what ignition are you going for?