sport quattro pics

[volcano rs]

nice Jamil. By the looks of it, the steel sprocket is not drysump compatible? Is that correct

its based on standard sprocket .when i finish doing the dry sump i'll have one made so it does the job .

[4WheelDrifter]

decided to have alloy front pully made for the shorty

Very nice. I want one too.

[volcano rs]

Very nice. I want one too.

lets see how it behaves on my engine first

[zlobo]

what's the spec on thoze azev rims? 17"x? et?

[volcano rs]

what's the spec on thoze azev rims? 17"x? et?

10x17 .if you are using standard quattro legs 9x17 will be ok

[zlobo]

i am going to use the legs from s2 on my spq

[volcano rs]

i am going to use the legs from s2 on my spq

with 10j wheel i had to put 15mm spacer to fill the arches .quattro hubs stick out further so you can get away with 9j wheels .you will also have to use the drive shafts from an s2 .what gearbox are you thinking of using ?

[Jamo]

How much will those steel sprockets cost?

Been looking at the dahlback one but it's mega money!

[zlobo]

with 10j wheel i had to put 15mm spacer to fill the arches .quattro hubs stick out further so you can get away with 9j wheels .you will also have to use the drive shafts from an s2 .what gearbox are you thinking of using ?

i will use everything from my donor s2, it will be 5 speed gearbox.

[volcano rs]

How much will those steel sprockets cost?

Been looking at the dahlback one but it's mega money!

cost £80 .how much are dahlbacks?

[newsh]

it weighs 1.49 kg compared to the standard 4.37

Can the engine still be balanced without the damper in the pulley? The weight in that thing is well off centre IIRC.

[volcano rs]

Can the engine still be balanced without the damper in the pulley? The weight in that thing is well off centre IIRC.

i'm having all the bottom end completely balanced .when the damper is worn and its wobbling all over the place it can't be in balance anyway .
those original pullys are expensive heavy and wear out .
i know almost everyone on here thinks you have to have vibration damper for balance but no one really knows for sure ,no one has really experimented they are just opinions .pembo has alloy one on his rally car and he said he's had no problems .
i've seen alloy pullys on v8 engines and so many jap engines they don't seem to have any problems .
i'll go along with someone with 40years of engineering experience and see what happens if he says it should be ok then i think it will be .

[Jamo]

cost £80 .how much are dahlbacks?

271 euros with VAT!

Steel cam gear for the crank shaft on 3B, ABY, AAN and ADU engines. Use with an adjustable cam gear is recommended.

Audi RS2 217 EUR 271 EUR

Seen them slightly cheaper on ebay

I'll be in touch about them

[zlobo]

271 euros with VAT!

Steel cam gear for the crank shaft on 3B, ABY, AAN and ADU engines. Use with an adjustable cam gear is recommended.

Audi RS2 217 EUR 271 EUR

Seen them slightly cheaper on ebay

I'll be in touch about them

You can get it for ~90€

[Jamo]

You can get it for ~90€

Where from?