My 3B-AAN 400 HP project

[Pirvu Eugen]

The rats had made their place on top off the engine.

[Pirvu Eugen]

Today i have dismantle the head!
Good condition at 220k km. except the valves guides.
This is how was before starting

[Pirvu Eugen]

Thanks for keeping my moral up!
I will try to find a block iff the lining is no option...

[jogi730]

Oh dear Eugen,
That sounds like bad luck. Hope you can sort it quickly and your project gets moving again.
Cheers
CHris

[Pirvu Eugen]

Somebody has try to reline an block?
Any success?

[Pirvu Eugen]

Not the best day!
After I found that the main crank seal mounted by me for an friend, after 4000 km is leaking badly and i dont know wy, I have start dismantle the engine for my project.
What i found is that the all bores are worned out at the top with 0.15mm.
I had a second engine.....dismantle and.....ofcourse....0.15mm wear
I dont have money for oversize pistons.
What to do? Please!

[kwlw]

the 034 head gasket for lower cr has 7 layers.. iff somebodi is interested.
i will measure the diference between the oem one and this.

Yes, somebody is interested

Sau

[Pirvu Eugen]

the 034 head gasket for lower cr has 7 layers.. iff somebodi is interested.
i will measure the diference between the oem one and this.

[Flat on my back]

.

Should give you an idea of what's available...

http://www.pirtek.com/

[Pirvu Eugen]

So the teflon ones like the oil lines from the cooler are working for gas also?
Super!
Thank You verry much!
All the best!
Eugen

[jtapio]

Copperlines work fine but you have to attach lines properly to body so they dont break down, copper may easily crack under tremor. my advice is that make thos lines teflon with stainless mesh coating , not the cheapiest but everlasting solution..

i think maybe shop who sell example pneumatic and hydraulic etc parts can help and prices may be lower than racing shops..

[Pirvu Eugen]

Hy guys!
Somebody has tryed the copper fuel lines?
What do you think?
Iff not good, can you direct me in the right direction for fuel lines and fitings?
Thank You verry much!
All the best!
Eugen

[Pirvu Eugen]

Thank you Chris!
For the moment i will leave the luck to you. I will not start till finishing the garage.
So Good Luck Chris!
I told you that when i come to England for remap i whant to have a ride in your red beast.
I will build the engine first!
All the best!
Eugen

[jogi730]

Intercooler

I have seen that air filter before some where

Good luck with your project, i hope you enjoy doing it

Cheers
CHris

[Pirvu Eugen]

I have found a good friend also!
He helped me ALOT!
Is good to have good friends!
Friend in need=Friend indeed!
heard this last evening!