Engine out shortly for a full rebuild. 
I'm waiting for a few parts to arrive so been doing fitment checks for the time being.
I'm waiting for a few parts to arrive so been doing fitment checks for the time being.
-
Last edited by ian4455; 5 March 2012, 19:35. -
What turbo did you go for?91 Modded 3B
14 A6 Avant Black Edition -
HX35 is the Plan.Comment
-
how much did that set you back?
Comment
-
Not much...
Comment
-
where from?Comment
-
Reverse Intake welded together, just need to sort the intake to throttle body. More fitment checks to come with front brace and intercooler, 7a cam cover with V8 Coil Packs
Comment
-
Looking good Ian, be interested which route you go down with the V8 coil pack conversion. Been trying the German guy who Andy P bought his coil conversion harness from but he's not returned any of my messages.
Did you do the work on the intake? 
Stuart
B2 90 quattro with boost
Comment
-
slight update, inlet flange offered up for welding
Comment
-
Hi, haven't figured out which way with wiring. May buy the plugs and make a loom myself as have the wiring diagram. Only problem is my engine loom is 3b and wiring diagram is for aby. I'm sure prj on here does the harnesses, maybe worth a PM to him!
Intake i cut the bits myself, marked them up and had them welded by someone else.Last edited by ian4455; 4 February 2012, 18:38.Comment
-
Update Stainless Steel Cross member with my new intercooler.Last edited by ian4455; 8 February 2012, 18:39.Comment
-
Update - 7a Cover, coil pack trimmed and offered up.Last edited by ian4455; 11 February 2012, 19:15.Comment
-
A little progress tonight, starting with new loom for coil packs but should i be using heat resistant cables ? Also in two minds to remove the air con, any points of view ?
coilpackwiring.jpgLast edited by ian4455; 5 March 2012, 12:21.Comment
-
Coil Pack wiring has turned out nice, it's easy to run the 5 new cables down to the ECU behind the battery through a spare rubber inlet on the fire wall.Comment
-
nice
I will go for the pin swap route too, but I want the coils to be at the bulkhead and run cables to the spark plugs if possible.
Comment
Comment