Danisch projekt 2012

[audinut]

they cost 47000 Danish kr

£5000 ?

[audi rs2 1995]

Can you comment on how you find the KW V3s, and how they compare to what was on the car beforehand, i.e. ..........

What roads and use is the car put to also as regards the suspension ?

Oh yeah, what engine management, it sure like to rev on the you tube dyno run.

Thanks.

I bought KW3 at a dealership in Denmark (bilexperten) they helped me find the right setup.

I have adjusted KW3 in the middle of hard and soft. and it seemed to work perfectly well for daily driving and race.

My engine management (FMJ) is made and bought in Denmark. I bought it ,because it can´t everything it should and it's plug and play so you don´t have to cut in the orignale wiring.

[audi rs2 1995]

£5000 ?

Year it´s was a moment of crazy

[audi rs2 1995]

123:

[audi rs2 1995]

Now the car is finished

[tejs]

Movie from Saturday.. enjoy

[audi rs2 1995]

123

[vcosmin]

The precision is rated for a lot more thank 570 - this was on the wheels , or crank ? also did you logged egt ? backpressure ? IAT ?

[audi rs2 1995]

123

[AUDIS2avant]

Looks good Jesper, A's i told you on the phone it's not the exh housing but either exh. Manifold airfilter or your porting on the head that is Way off, but hope for the best in the next dyno session.

[V6quattro]

Grade movie! How did you made it FWD? Just take out the prop shaft and weld the torsen?

[macspring]

I bought KW3 at a dealership in Denmark (bilexperten) they helped me find the right setup.

I have adjusted KW3 in the middle of hard and soft. and it seemed to work perfectly well for daily driving and race.

My engine management (FMJ) is made and bought in Denmark. I bought it ,because it can´t everything it should and it's plug and play so you don´t have to cut in the orignale wiring.

When you say help you find the right set up.

Was that the adjustment of the rebound and compression settings, or was it to choose particular ratings of the springs ?

Fantastic photo in post # 54.

Thanks.

[geryS2]

what a beast !! impressive

[tscheel]

Very nice!

Who made the exhaust, can you recommend him/her/them? I need someone to fix my custom 3" - it's too low all the way, and runs under the rear axle

My H&R's are waiting..

TIA

[audi rs2 1995]

Grade movie! How did you made it FWD? Just take out the prop shaft and weld the torsen?

Yes just right