Projekt Alpinweiss IV Part II - 350 bhp

[andy10v]

Looks lovely!

[SteveH]

Nice one Andy! Are you going to the RR day at MRC?

[Rusty]

Cheers chaps

Not going to the RR day Steve

[Error404]

Looking very clean mate

[Rusty]

I think I'm going to up the rear spacers to 10mm, still looks a bit slim-jim.

[Error404]

Thought you were using the 15mm ones?

FWIW I run 12mm rear spacers on mine to balance the track width front to rear

[Rusty]

I have 5mm, 10mm and 15mm available

The wheels are 17x8 ET35 with 225/45R17 track rubber front and rear (Yoko AD08 7 Pirelli PZero Corsa), with the fronts au naturel and the rears running a 5mm spacer to balance the looks. I bought the 15mm items to run with the OE Avus but may even go to 20mm, if they look a bit inboard when I go back to the winter wheels.

I also have some rubber spring assistors to try on the rear, to 'stance' it up a bit. If it looks good, I'll get some HnR Avant front springs to add extra stiffness and height over the HnR Coupe rear items and maybe drop the RARB size a little to prevent inner wheel lift under hard & tight cornering.