S2 avant project
Collapse
X
-
Current-2004 Impreza PPP wagon
Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
Sold ABY-stockComment
-
-
Well spotted! The winner

I have been restoring for two years, full body soda blasting and re sprayed.Attached FilesComment
-
Sweet sound
Exhaust all done sounds perfect, and a nice job with down pipe and extra lambda senor port for mapping.
Comment
-
Brake up grade allround fitted.
Hopefully back on the road Wednesday
and get to see how good this is going to stop? Very pleased with how the rear conversion has fitted, very little fettling needed and all with the information of the fourm 
Comment
-
I pop up to my friends to see this while 3"tbe system was getting made last Tuesday look very clean inside and out and engine bays a wellNow have all brake kits waiting for fitting tomorrow after I have picked her up from top gear performance in Doncaster where full 3 inch s/s exhaust is being made and fitted, picking car up in the morning.
New wings have been fitted and painted and the hole car machine polished last week done at my mates place N H Performance near Loughborough, If you are located in the east midlands and need body work and paint you wont get any better.
Hopefully will be able to get some miles on her before the 22nd of December before live map day.
Last pic is of other rebuild going on, can you tell what it is yet??
Comment
-
Live remap tomorrow
At last the day has come for re map hopefully all goes well with no problems.
Comment
-
live remap complete
This will be the short version as I have just lost a 40 minutes of my life writing this once before, loosing it when I pressed preview!!

I arrived at Automark and had a chat with mark regarding what had been done to the car and what I wanted to achieve.
As one of the lads got the car ready for a boost leak test mark and I flow tested the big green bosch injectors that I had taken with me. These turned out to be all dam close to one another, although a bit on the large side as they flowed 100% more fuel then a standard RS2 injector
Back in the garage Mark asked the question " where are the leaks?"
"There isn't any! " came the reply. Held 2 bar of pressure with smoke, Well done Rich



In all the years mark has been tuning cars he has NEVER not had a boost leak on car that has been taken to him.
On the road the K24 7200 with clipped blade turbo was keen on producing boost early on and produced all the way up to the limiter @1.8 bar max.
It leaves my fiancé BMW 335i coupe wanting, or as she put it after the pub
" You get a smell of fuel and then it just F**KS OFF.

Comment

Comment