oil breather hose/pipe

[dirtybarry]

where would be the best place to get hold of a new oil breather pipe for my 3b. part no. 034103221bb. as i just found a split in my one.

[Greg_S]

vagparts is a good bet, click the banner link at the top

[dirtybarry]

some pics of the culprit.

[dirtybarry]

,.,.,

[newsh]

Ah, that old chestnut

[dirtybarry]

just reading your previous threads on these now newish. think i will try making my own. i certainly ain't payin £96 for one.

[newsh]

just reading your previous threads on these now newish. think i will try making my own. i certainly ain't payin £96 for one.

Good move brother
Do you have access to a lathe? I can give you dims of the part. S2Bo has one unfitted at the mo, you could ask him to take some detailed pics before fitting.

[dirtybarry]

my mate has access to a lath. if you could give me the dims of the part you made i can pass them on to my mate. should be a dam sight less than £96 sheets.some detailed pic's from s2Bo would be great too. god dam this site is good.

[dirtybarry]

would the full samco hose kit (part1 & 2) include these pipes? also newish, need all dim's, internal diameter, external dim, lengths, width, ect.

[newsh]

Instructions for the "newsh PCV Mod" (The adaptor that saves you buying a bit of rubber pipe for £96 +VAT)

I use piece of 40mm ally bar 60mm long.
Reduce one end to 30mm dia x 20 long and the other to 20mm dia x 20mm. Bore out to leave about 3mm wall thickness.
Drill a hole though the side of the center section and tap a 12mm thread.
Take a piece of 12mm studding and turn the threads off one end and drill through with about 6.5mm drill. Screw into the reducer part with some PTFE tape to seal it and lock off with a thin M12 nut.

Sorted.

The one below was an earlier version before I discovered the trick of locking the side branch with a nut, I used to locktite the thread in.

[newsh]

None of the PCV stuff is included in the Samco kits

[s2_bo]

my mate has access to a lath. if you could give me the dims of the part you made i can pass them on to my mate. should be a dam sight less than £96 sheets.some detailed pic's from s2Bo would be great too. god dam this site is good.

Will put up some pics after lunch

Cheers.
Bo

[s2_bo]

Sorry for the delay:

IMG_1452.JPG

[s2_bo]

[ATTACH]11230[/ATTACH]

[s2_bo]

[ATTACH]11232[/ATTACH]