AC pipes

[newsh]

I need the 2 pipes that go to and from the AC compressor on an ABY.

TIA!

[Doug_RS2]

I think I have them - I took one off the compressor recently and the other should be there as well - PM me an address and I will send them to you.

[newsh]

Done

[Doug_RS2]

Which hoses do you want John? It's been that long since I took mine off I can remember which are which.

[newsh]

Bloody hell, I think its the 2 in the middle, deffo the one with the solid bit with the kink in it, that one looks right, I'll have to check the other one, I thnk it has an elbow at each end at 90 deg to each other, whats hiding behind that ally sheild on the LH middle one?

[newsh]

OK yes, just checked, its the 2 in the middle of the pic, perfect!

They dont weigh much, wonder whats the quickest way to get 'em here?

[Doug_RS2]

OK yes, just checked, its the 2 in the middle of the pic, perfect!

They dont weigh much, wonder whats the quickest way to get 'em here?

I will get them wrapped and packed and sent 1st class - it will probably be tomorrow before I can get to the post office though. is that ok?

[Doug_RS2]

the ali shield is a cloth shield - I think that protected the pipe from the EM - there is a connector underneath it - I think it just slid along the hose.

[newsh]

the ali shield is a cloth shield - I think that protected the pipe from the EM - there is a connector underneath it - I think it just slid along the hose.

Thats it, perfect

Tomorrow is ok, want to get them on this week if poss, to stand a chance of getting it gassed up before my hols the week after. Never had AC actualy working before ...

[Doug_RS2]

I managed to get to the post office this evening efore it shut - just - so hopefully you will get them tomorrow.

[newsh]

I managed to get to the post office this evening efore it shut - just - so hopefully you will get them tomorrow.

Superb!

[newsh]

Think I've sussed the connection problems Doug, different coloured O rings, so maybe my system was the old gas and your's was the new? anyway, the nuts on the unions are the same size, but the threads inside them are different, yours are 1mm larger diameter. So when we tried to connect the pipe to my drier/accumulator unit the nut just went round and round as if it was stripped. Prob no point using your drier as we'll have the same problem on the other side of it, so we're going to put one of my rt angle ends on your pipe and see how we go from there.