vems 1.1.63 wanted

[s2martyn]

i need the above firmware if any users have it stored...it is not available now for download..without this my job is hell

[A80Avant]

http://www.vems.hu/download/v3/firmware/obsolete/oldhex/

Download it from here and then install the zipped file on the same folder as the one that vemstune uses for the other firmwares

then once you reopen vemstune, you will see the firmare 1.1.63 there, and all you do is reinstall.

[Jamo]

The folder is webcache\fw I found the old hex dir as a80avant posted up

[s2martyn]

thanks guys got it..settings still not saving only ve tables....tryed a few vemstune versions to no avail..
going to get the camera out tommorow and start inputting the data manualy

[s2martyn]

i have also been advised to use 1.1.81 as this is the most stable,what are others using?

[Jamo]

1.1.81 got superseded by 1.1.94 or 1.1.95, i've seen no difference between 1.1.81 and the other officially released firmwares in terms of stability

http://www.vems.hu/wiki/index.php?page=GenBoard%2FUnderDevelopment%2FFirmwareChanges

You have a choice of 1.1.81, 1.1.85, 1.1.94 or 1.1.95

Personally I would say 1.1.95 it's the latest I'm running it so is A80avant

[s2martyn]

so to clarify..when i upgrade over 1.1.70 after this all the fimwares can be uploaded WITHOUT unplugging injectors etc,AND I WILL NOT HAVE TO INPUT THE DATA MANUALLY AGAIN?(this i could not cope with)nor do i want to do it again

[Jamo]

No you have to be over version 1.1.83 http://www.vems.hu/wiki/index.php?page=SafetyMode

[A80Avant]

i wasnt aware of this regarding the coils and injectors from 1.1.83, so i did take the plugs off, installed the firmware, and put the plugs back on. Simple and doesnt take long.

you need to make sure you use a timing gun to set the timing again from 1.1.63 to 1.1.95

and i would suggest 1.1.95 as an upgrade.

[s2martyn]

i am just going to go to car and start this procedure.....will i be able to get comms to the car with the current vemstune 16.6.2011 or will i have to use old one that car was set up with?

[A80Avant]

as i mentioned, use what you have, photograph every setting on your masic settings menu and all that values are not existent when you disconnect the ecu from the laptop. Then use the latest vemstune, reconnect and start the procedure of the upgrade

[jade]

i am just going to go to car and start this procedure.....will i be able to get comms to the car with the current vemstune 16.6.2011 or will i have to use old one that car was set up with?

Not 100% sure, but I think you have to upgrade to something like 1.1.74 then to the new ones I went 1.1.74 to 1.1.88 to .1.1.95

[s2martyn]

will all this work with serial cable as i dont use usb

[A80Avant]

i use serial cable as well. Much easier to communicate than USB. No drivers required

[s2martyn]

what is base timing figure??
8 degrees at idle???