Trigger Problem

[murat]

I have trigger error with vems, using stock rs2 setup, everything stock except vems.

I have trigger errors like in the video, sometimes they can be seen in bigger amounts like hanging rev needle for some time when decelerating.

Here is the video




What are the possible solutions for this.

Currently using divbyn 27, it was same for 9 also.

[Biturbo]

Try put sensor closer to flywheel

[murat]

engine is out now, so i can also enlarge the pin but not sure which one is better

[Biturbo]

engine is out now, so i can also enlarge the pin but not sure which one is better

I had same problem with 7a flywheel.Put sensor closer and use div by 27 then no more errors

[murat]

I had same problem with 7a flywheel.Put sensor closer and use div by 27 then no more errors

Mine is stock rs2 flywheel if that makes any difference

Is there a thread showing how much and how to grind the sensor?

[Biturbo]

Mine is stock rs2 flywheel if that makes any difference

Is there a thread showing how much and how to grind the sensor?

rs2 flywheel is better then 7a for trigger.Try use normal setings not div by 27 or 9.Then I use with my s2 aby flywheel it was good on normal audi trigger.I take about 0.5mm from that sensors plate to put it closer

[murat]

What do you ean by normal?

You mean divby3

I also hve this problem on divby3

On stock motronic I dont have this issue.

[A80Avant]

I had to put the sensors closer AND enlarge the pin to make it work at all with the 7a flywheel

sent with Nokia 5110

[murat]

so we grind the flange of the sensors right?
Is 1 mm enough?

[Biturbo]

What do you ean by normal?

You mean divby3

I also hve this problem on divby3

On stock motronic I dont have this issue.

yes select from that option on vems audi trigger.
Vems need better signal then motronic on this

[Biturbo]

so we grind the flange of the sensors right?
Is 1 mm enough?

just not too much then you will damage sensors

[kamuto]

firs off all you need to see what sensor signal is bad. primary or secondary... so just make log first, and make it downloadable.

[V6quattro]

engine is out now, so i can also enlarge the pin but not sure which one is better

If your engine is out you can place a 60-2 HALL wheel on your crank.

http://www.s2forum.com/forum/showthread.php?t=36034&highlight=60-2+wheel

[Billman]

I had no issues with stock RS2 flywheel.

[A80Avant]

Me neither

sent with Nokia 5110