which way to go

[denniselbows]

just a quick question what front brakes are you all using

[s2driveruk]

porsche 996/boxster 2 monoblock calipers, audi a8 323x30mm discs and Ferodo Ds2500 pads with RS2 hardlines. Well practised mod on here and parts reasonably priced and easy to get hold of. Do a search on here for any of those and you'll stumble over hours of reading

Good luck

David

[shaun5]

hi mate. there are loads of kits, mov it, AP, all depends on what wheels you re gunna upgrade to? need to get your brakes done before u fit your engine bits. dont wanna crash it again(third time lucky!!!!)

[denniselbows]

thanks for that tip shaun

[Crawford_S2]

porsche 996/boxster 2 monoblock calipers, audi a8 323x30mm discs and Ferodo Ds2500 pads with RS2 hardlines. Well practised mod on here and parts reasonably priced and easy to get hold of. Do a search on here for any of those and you'll stumble over hours of reading

Good luck

David

Same for me, good cost effective upgrade!

[Greg_S]

Using AP 330 x 32mm discs 4 pots and DS2500 pads up front

[Rusty]

BRY sourced kit consisting of 996 monoblocks, Textar pads, grooved 314mm discs, custom brackets, RS2 hard lines and all hardware . Send him a PM for what he's got available.

2nd hand 996s are a very cost effective way to go and will fit under the ABY alloys, not sure about the 3B alloys though. Obviously not a consideration if you're fitting new alloys just looking at your avatar).

[Jay]

Corey

Try the supremo Corey AKA Quattronics on here, he has a wealth of knowlledge in this field and lots of stock of nice shiney brake bits


Jay