I hate S2, UrS4, UrS6 rear calipers!

[Animal Mother]

Just took 6 hours to change rear discs and pads because of the "great" design of the rear calipers.

[Acidburn]

What was the problem? getting the calliper off, winding back the piston?

did you have all the correct tools?

[shark_90]

Quite.. what exactly was the problem??

[Fat Audi 80]

Wind back tool???

[Animal Mother]

Just noticed I put 6 hours, I meant three, 6 would be a complete brake rebuild. lol

Wind back tool???

Oh yes, what a pain in the **** that is!

Siezed carrier on one side too.

Siezed pads on both sides.

At least I found the reason my hanbrake was holding on.

Wasn't as bad ad the front subframe bushes and front arms and ARB bushes I did last night. That was fun.

Suspension is tight like a tiger now though.

4 wheel alignment on Monday.

Should all be set for the ring next week now.

[Big Lee M]

Bloody hell I was going to say 6 hours. You could have rebuilt them in that time I bet? Glad you've got it all sorted for the ring. Can't wait to go there hopefully in May next year but as you know lots to sort out in a short time(leave it to the last min,well that's what I normally do)Well at least you've got it sorted, hope you have a good time

[Animal Mother]

but as you know lots to sort out in a short time(leave it to the last min,well that's what I normally do)Well at least you've got it sorted, hope you have a good time

Tell me about it. All last minute. New plugs and plug boots go in on Monday as well as alignment. I leave on Monday!

I have an ABS light on too, I think it's a sensor. I'll have to get that sorted in ze Fartherland though.

[Big Lee M]

Done the proper way like a Audi driver................