ABS light not working

[Antsa]

My car is a -93 Avant ABY. Problem is as follows: when I turn the ignition on, the ABS light doesn't come on for a few seconds how it should. ABS itself works ok. Previous owner thought it was a instrument cluster fault, but i've tried a different cluster and the problem persists.

I've checked that the abs bulb and the bulb circuit in the cluster is ok with a multimeter in continuity check and checking the cluster blue connector pins T26a/10 and T26a/16. Then I checked if the pin T26a/16 gets 12V when ignition is on. That's ok too. Then I thought I'd try continuity between T26a/10 and ground, but according to the wiring diagram the grounding runs through J106 (ABS solenoid valve relay) and J104 (ABS Control Unit) and I was afraid to blow the control unit so I didn't do it. Obviously the fault it somewhere in the ABS bulb grounding circuit? Anyone got any ideas how to proceed?

I have used this wiring diagram. I've also read this thread. Could not find any relays with fuses in them. Could not even find any ABS relays. Not in the auxilary relay panel and not under the rear seat. Fuse box in the engine compartment did not even have the fuse diagram in it. So if there is an ABS relay/fuse, I have no idea what it is

Edit: Even the ABY fuse box diagram would be much appreciated

[Antsa]

Fault found!! Took the big abs control unit connector out and checked the wire from ABS bulb to that connector and guess what? That yellow cable w/red stripe was broken. Had to strip almost the entire car apart to find the spot where the wire was cut. What a PITA job to do. Finally found the right spot under the dash, fixed the broken cable and the ABS light now works as it should

[newsh]

Good work!

[Antsa]

Thanks man!

And I still could use the ABY main fuse box diagram if someone has it

[Error404]

Is this what you need?

[Antsa]

That might come in handy some day! But actually I was looking for the sticker that should be printed inside the main fusebox cover. The one that reads which fuse and relay does what. I'm not shure if diagram is the righr word for it though

[newsh]

ABS light not working

http://www.s2-audi.co.uk/tech_articles/electrical/engine_fuse_box.htm

It's on the outside of the cover

[Mikes2]

And if you hover over the word Fuses, you'll find a hot link that lists each fuse in a table

[Antsa]

That is the pic I was looking for!

Thanks