how to do k pin mod on urs4 please

[diesel des]

I have read through loads of threads, but most are based on the s2, or others cut tracks to stop just the headlight sensing. So where is the relay on a urs4 that needs its k pin cut to shut up the dam bulb alarms in autocheck. All my bulbs are fine and connections good but I get random bulb warnings, some for brake lights, others for side lights. So I just want to kill all bulb warnings.

I found a relay under the bonnet in the relay box that had 2 k pins. Removing these 2 pins just give constant alarms, so is there another relay I need to adjust. Cheers des

[Thuppu]

You need to do it like this: http://forums.quattroworld.com/s4s6/msgs/19604.phtml Works great, no warning about broken headlights but it still check the brake bulbs

[diesel des]

Thanks for the link. But I want to disable all bulb alarms as mine sometimes tells me a brake bulb is blown when it isn't, not just headlamps. Thanks des

[Thuppu]

1. Open the module
2. Connect KB and KS to grund 31
3. Cut both KB and KS conduits on the circuit board with a knife etc.
4. Put the module back together and listen to the silence


UrS6 lamp control module pin label function:

18 58L left parking lamp power
17 58L1 left parking lamp
15 56BR1 right headlamp
14 56BR right headlamp power
13 56BL1 left headlamp
12 58R1 right parking lamp
11 56BL left headlamp power
10 58R right parking lamp power
9. KS heradlight signal to auto check system - grey
8 54L left brake light
6 54H high mounted brake light
5 54 brake light power
4 54R right brake light
3 KB brake light signal to auto check system
2 31 ground
1 15 ?

[Zoig]

Is there any way to get the bulb monitor to check the foglights instead of headlights?
If i replace headlights with xenons and use fogs as DRL's then it would be good to have the bulb monitor checking the fogs.

[johne]

Is there any way to get the bulb monitor to check the foglights instead of headlights?
If i replace headlights with xenons and use fogs as DRL's then it would be good to have the bulb monitor checking the fogs.

Yes but you'd have to do quite a few wiring changes bypassing the module for the two power feeds to the headlights and then changing the wiring for the fogs so it passes through the bulb check module instead of the headlights.

The wiring diagrams on S2Central.net will help you.

John

[diesel des]

Good man. I know what I'm doing tonight then...

[diesel des]

Good man, I completed the mod tonight and all went to plan. The autocheck says a big ok as soon as I turn the ignition on. Thanks for the help.

[diesel des]

Right, my car still thinks I have a bulb out when I hit a bump or go round some bends. I'm thinking there is a bad connection or dry joint in the autocheck or clocks as when I hit the dash the warning sometimes starts or stops. Where should I go looking. Cheers des