What is the size of the outlet at the side of the block, that is the lower crank outlet. It is for my 3b catch tank setup, where the lowest arrow points.
/Jonas R.
/Jonas R.
-
Last edited by Jonas_R; 1 July 2005, 15:15. -
If I remember right, the outlet OD is 30mm with a 32mm bulge in the end of it. So for a tight fit use 30mm ID hose, or you can use a 32mm ID hose for easier fitting and tighten it in with a hose clamp.
Mine didn't have a flame resistor or I didn't find it when I made a replacement part for that 1a -part in the picture.Last edited by JariP; 30 June 2005, 21:38. -
Dude i think you saved my day
now i can go out tomorrow and buy some oil resistant hose i get on with this
Thx.
/jonas R.Comment
-
Comment