200T Motor into 90Q ? any tips? worthwhile?

[CR500Dom]

My 90Q currently has a 2.2KV 10v, and I am looking at doing something with it.

Just seen a 200 turbo being broken and wondered if this would be a cheap and easy swap and what sort of Gains would I be looking at ?

Anyone been here before ?
Is there anything in particular I would need from the Donor apart from the Usual Engine, Loom, K-jet set up ?

I have the Auxillary rad in mine already so the cooling system should be OK

As always, any help will be greatly appreciated

Cheers
Dom

[Dave cook]

Mc/Kg 10v turbo in to 90Q

boost!!

hope this helps

[Jas11n]

My 90Q currently has a 2.2KV 10v, and I am looking at doing something with it.

Just seen a 200 turbo being broken and wondered if this would be a cheap and easy swap and what sort of Gains would I be looking at ?

Anyone been here before ?
Is there anything in particular I would need from the Donor apart from the Usual Engine, Loom, K-jet set up ?

I have the Auxillary rad in mine already so the cooling system should be OK

As always, any help will be greatly appreciated

Cheers
Dom

Speak to "New Convertor" (Russ) on here. He's had a 20v turbo motor put in his 90q recently. His was a 20v 90q, though that shouldn't make a big diffrence. Conversion done by Tim at QRSport.

HTH's
Jas

[porkkis]

You need the RH side tie rod from urquattro if you're using std 10v turbo EM. I dunno how tight everything is on a RHD car near the WG area. Possibly need some other urq bits too.

[quattronutter]

you will also have clearance problems with the brake servo and master cylinder,however it will fit with a few mods,ie hammer to servo.......