MSD ignition

[Rocco]

My plan is to run RS2 setup on 3B standard distributor ignition. Point is, maybe MSD coil is better (will secure 1.8-1.9 boost) than oem 3B coil? I don't want any missfire trouble

I was using my RS2 to 3b software with stock but new ignition parts with 2.0 bar boost .

And NEVER,NEVER!! Had a problem

[prj]

Combo, 3 bar fpr
044 pump,
Rs2 injector
High flow rs2 manifild
Rs2 turbo
7A cams
300 kPa map

RS2 injectors with 3 bar FPR do not make more than about 320 hp.
So either your numbers are wrong, you are using some fuel with higher energy density than gasoline or you got your specs wrong.

Very simple.

Just killing myths before they are started. Last person who claimed 400+ hp on RS2 injectors at 4 bar on this forum - I got those very injectors in my own hands, and tested them.
They were modified and were flowing over 400cc/min.

[Rocco]

RS2 injectors with 3 bar sensor do not make more than about 320 hp.
So either your numbers are wrong, you are using some fuel with higher energy density than gasoline or you got your specs wrong.

Very simple.

Just killing myths before they are started. Last person who claimed 410 hp on RS2 injectors on this forum - I got those very injectors in my own hands, and tested them.
They were modified and were flowing over 400cc/min.

I know some clever guys in Spain using RS2 turbo with 3b injectors and fpr...