blink codes

[marty]

any one help please im trying to read blink fault codes as per s2 central all i get is that the lamp is permanently lit
problem is i fitted boost gauge yesterday and cant get more than 0.4 bar any time.
any coments
thanks martin

[Pisobiker]

that is strange.
I did the same too, following S2Central.net instructions with the bypass cable and 12V light. And it worked fine.

Are you sure you bypassed the correct poles for at least 2 seconds before taking bypass off?

Marco

[marty]

strange, thats what i thought i connect lamp black conector and blue conector and it lights up ingnition on or of jumper in or out tride and tride agian still same

[Pisobiker]

Sorry Marty, cannot be of help.

Only thing I can say is:
when you insert the jumper, be sure you do it securely. A couple of times happened to me while bypassing, that the connection was interrupted just a fraction of sec. before the 2 seconds (this because I wasn't holding the cables firmly enaugh) so the stuff didn't work.

If you did everything correctly and still doesn't work, maybe Mihnea and Paul N. can tell you why.

Marco

[marty]

Tried again still no joy got the dash in bitts now ill try wiring the MIL light see wat that does
thanks marco